Chemical disinfectants and antiseptics. Quantitative suspension test for the evaluation of fungicidal or yeasticidal activity in the medical area. Test method and requirements (phase 2, step 1)1 Scope This European Standard specifies a test method and the minimum requirements for fungicidal or yeasticidal activity of chemical disinfectant and antiseptic products that form a homogeneous, physically stable preparation when diluted with hard water, or in the case of ready to use products with water. Products can only be tested at a concentration of 80 % or less (97 % with a modified method for special cases) as some dilution is always produced

Verification of the common mode impedance at the EUT port of coupling and decoupling

These sub-categories are distinguished on the basis of different fibre types or applications

hazards generated by neglecting hygienic design principles

Use these definitions to define a set of standard operations that will form the basis of compliant systems and thus act as a test‑bed for implementers and a benchmark set for validation of compliance

and exchanged between functions

This part of IEC 60143 specifies testing of thyristor controlled series capacitor (TCSC) installations used in series with transmission lines

pushing and pulling) or animal handling

NOTE 1 These standards have been developed by CEN/TC 241 under the Mandate M/106 “Gypsum products” and by CEN/TC 112 under the Mandate M/113 “Wood-based panels”

installing and operating drain and sewer systems that operate essentially under gravity

c) energy management of power flow between vehicles and fixed installations

BS EN 13141-3 on range hoods is useful for:

It is applicable to elastomeric seismic isolators used to provide buildings with protection from earthquake damage